X problem...

It seems you loose steps in fast moves, I assume in X.

I don't have G-Code file to check or any knowledge what your controller or SC type is so it's hard to make any other analysis.

I'm using a SC 600
but i can't attache my files??

Sow I'm making something like pic1 for a year now.
But since two days it's doing something like pic2.
When I run the machine manually, there is nothing wrong.
The problem seems to happen when it moves from the first cuttingform to the second and every step inbetween cuttingforms.

HELP 🙁

are the rectangles machined with square edges? If yes- then you are loosing steps in X as the machine is rapid moving between cutting.

Check your machine and tuner her up 🙂

https://www.youtube.com/watch?v=zs7OTxZoik4

I'm using a SC 600 but i can't attache my files??

I have also SC 600. Anyhow, you can attach only picture with max size of 1024x768 and ZIP or TXT files as far as I know.

I'm using a SC 600
but i can't attache my files??

Zip the File and it

Hello. My first day using my SC 430 and everything was going well. Than there was a problem in X-axis. When doing homing , it keeps jam at same position. I also remove the screw and motor, and fix again. And again it fails on homing. I really dod not know what happens . Any suggestions?

Did it jam at the end like just before the limit switch?

Is this topic still active, because my new machine locks up just before the limit-switch on the x-axis