Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
3
Beiträge
3
Benutzer
0
Likes
5,639
Ansichten
Themenstarter
Hello All,
New to SC and just assembled a SC2-600 with UCCNC and UC100. Everything works fine and I loaded a SC600 profile supplied by the retailer here in Aus.
Problem is that whenever I load G-Code and start the cycle the Z axis immediately triggers the hard limit switch stopping the entire process.
I'm new to desktop CNC so not sure how to fix the issue.
Any suggestions and tips welcome.
Thanks
Frans
Veröffentlicht : 27/05/2015 3:48 pm
Triggering the switch looks like it is moving in the wrong direction. It shall go down but it goes up.
Should be possible to change that in your software settings.
SC 420 mit DIY parallel + Proxxon mit Mod + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +WinPC starter/USB->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch
Gruß, Andreas
Veröffentlicht : 27/05/2015 4:37 pm
Does it retract up into the limit switch?
you can change this in the CAM? Safe Z?
Veröffentlicht : 27/05/2015 9:28 pm
