Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
3
Beiträge
2
Benutzer
0
Likes
6,915
Ansichten
Themenstarter
Hi, I see that there are serial ports on the back of my 420 and the 350w motor controller. Am I able to connect the two and have control of the spindle via UCCNC?
I haven't tried this yet in case bad things happen!
Thanks,
coanda
Veröffentlicht : 22/03/2015 1:45 am
yes - you will be able to control the spindle. There is a relatively slow optocoupler on the STEPCRAFT control card. Therefore the PWM frequency output at max RPM is important. the new version of the UCCNC that we are testing allows you to change the PWM frequency at the max RPM. So we will soon have it configured.
Veröffentlicht : 23/03/2015 1:58 am
Themenstarter
That's good news. Thanks for the info.
Veröffentlicht : 23/03/2015 2:39 am
