Fusion 360 -> WinPC-Nc USB4 Z trubble

Hi!

- Stepcraft 2 d840, used, cleaned, rebuilt, adjudted and greased.

- basic settings from loaded machine model file and applyed relevant data for cooedinates and speed and data.

- motortested and runs fine from winpc-nc.

- test drive according to start guide ok.

- simulation in Fusion 360 looks fine.

- machine simulation in Fusion 360; Z = -80 mm and colides with fixture, that is whats giong on when I start the NC program i winpc-nc. So far I have bin able to hit stop so no aluminum particles!

Fusion post processor is "winpc-nc" downloaded from autodesk website.

Please give a hint if you have a solution to this!

Take car and make 2025 the best one!

/Jonas