Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Milling
2
Beiträge
2
Benutzer
0
Likes
4,716
Ansichten
Themenstarter
My Machine has been working fine up until I had to fix a snapped wire on the Z axis
Since the repair when cutting a profile my spindle suddenly keeps plunging through the wood despite the depth being set less than wood thickness.
When milling pockets or V cuts no problems,
I am using Vcarve & UCCNC on SC600 v2 and the fault occurs with both my proxxon spindle and my larger router spindle.
Veröffentlicht : 22/08/2016 8:39 am
Did you insulate the broken cable against ground perfectly? May be cable touches ground in some positions or maybe there is another location on the cable where it touches ground? I would examine the complete cable.
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11
Veröffentlicht : 22/08/2016 12:12 pm
