Benachrichtigungen
Alles löschen
Milling
2
Beiträge
2
Benutzer
0
Reactions
4,981
Ansichten
Themenstarter
My Machine has been working fine up until I had to fix a snapped wire on the Z axis
Since the repair when cutting a profile my spindle suddenly keeps plunging through the wood despite the depth being set less than wood thickness.
When milling pockets or V cuts no problems,
I am using Vcarve & UCCNC on SC600 v2 and the fault occurs with both my proxxon spindle and my larger router spindle.
Veröffentlicht : 22/08/2016 7:39 am
Did you insulate the broken cable against ground perfectly? May be cable touches ground in some positions or maybe there is another location on the cable where it touches ground? I would examine the complete cable.
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11
Veröffentlicht : 22/08/2016 11:12 am
