First steps towards pcb's

Hi,

Making progress towards milling my first pcb. I had a design already suitable for a trial run and used the free "pcbgcode" software to process an Eagle .brd file. I added a flood groundplane and a copper pour over the rest of the board to minimise milling required.

The resultant files I then imported directly into UCCNC and plotted these out just to see how well the G-code coresponded to the original. I must say the results appear quite impressive, bearing in mind that the drawing ballpoint was relatively large.

This is the original Eagle layout screenshot

Test drawing of the untouched G-code