Benachrichtigungen
Alles löschen
Laser engraving
2
Beiträge
1
Benutzer
0
Reactions
3,780
Ansichten
Themenstarter
Hi all,
Just setup up the laser dl445 on my 840.
Couple of things going wrong.
Getting an error when probing that says
'the probe sensor was active. The operation was aborted."
And then when I manually setup the Z-zero and used the laser-test.nc file the laser drew a square that was five mm less than the given 40mm.
Any ideas?
Thanks in advance.
Hassa
Veröffentlicht : 28/01/2019 3:57 pm
Themenstarter
Fixed Issue.
Thought id Leave a Note to let people know its been solved.
Was a problem with the Macro M31 and my calipers were wrong on the measurements.
Veröffentlicht : 31/01/2019 2:01 pm
