- Beiträge: 3
- Dank erhalten: 0
Frage
840 @ ISD
- Robert@isd
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
04 Dez 2015 00:20 #27831
von Robert@isd
840 @ ISD wurde erstellt von Robert@isd
Hi,
Robert here; I teach at ISD in Indy.
Indiana School for the Deaf.
We just acquired an 840 through a grant.
So far, so good.
Using Blender to create paths and it's a treat.
Here to learn a bit more.
Anyone make a vacuum table for their stepcraft?
Robert Wilson
Robert here; I teach at ISD in Indy.
Indiana School for the Deaf.
We just acquired an 840 through a grant.
So far, so good.
Using Blender to create paths and it's a treat.
Here to learn a bit more.
Anyone make a vacuum table for their stepcraft?
Robert Wilson
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- speedo
-
- Offline
- Forum Nutzer
-
- 420v1 / Sorotec Vakuumtisch / EstlCAM+CNC
04 Dez 2015 07:48 #27837
von speedo
Daniel
zenziwerken.de « dxf-downloads von kreativen Projekten
cnc-wiki.de « lesen ... lernen ... fräsen
speedo antwortete auf 840 @ ISD
Hi Robert,
I created the cnc-wiki , which works like an index for the forum ... at the moment available only in German. Maybe you can acquire some information nonetheless:
http://cnc-wiki.de/Modifikationen/Vakuumtisch
I created the cnc-wiki , which works like an index for the forum ... at the moment available only in German. Maybe you can acquire some information nonetheless:
http://cnc-wiki.de/Modifikationen/Vakuumtisch
Daniel
zenziwerken.de « dxf-downloads von kreativen Projekten
cnc-wiki.de « lesen ... lernen ... fräsen
Bitte Anmelden oder Registrieren um der Konversation beizutreten.