- Beiträge: 212
- Dank erhalten: 31
Frage
How works the "search" function on this forum?
- julius
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
22 Mär 2018 11:13 #53346
von julius
SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple
How works the "search" function on this forum? wurde erstellt von julius
Hi,
the search function is nerving me. After writing a keyword in the "Search" tab above the forum I'm redirected to a page where one can refine his search.
I see below something "120 results", how to display them?
At the bottom of the page there are just two buttons: "Search" (again?) and "Cancel".
All is quite noisy and complicated, IMO.
the search function is nerving me. After writing a keyword in the "Search" tab above the forum I'm redirected to a page where one can refine his search.
I see below something "120 results", how to display them?
At the bottom of the page there are just two buttons: "Search" (again?) and "Cancel".
All is quite noisy and complicated, IMO.
SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple
Bitte Anmelden oder Registrieren um der Konversation beizutreten.