Notifications
Clear all
Topic starter
hello, but nowhere appears the difference of buying a parallel machine, or USB pro version (+ 199.00 euros), I understand it's a software upgrade, but which differences with the standard version, visit the website of the software, but neither it is clear that it is not specified which version is 199 euros. Friends if you could clarify this doubt, I'll be very grateful. thanks
Posted : 19/04/2015 10:37 pm
The standard offer includes the USB board with the starter version of WinPC NC. For +199€ you get the full version of the software. For -19€ you get the machine with a parallel board and without software.
The starter only supports 2 tools and plt-files. Plt means that you can only do 2D milling. For 2.5D you have to put more manual work into the CAM and milling. 3D is out of scope.
WinPC NC starter does not support any additional hardware, like the 3d printer head, the 4th axis, the tool length sensor and so on. And the number of settings you can do in the SW has been highly reduced.
SC 420 mit DIY parallel + Proxxon mit Mod + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +WinPC starter/USB->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch
Gruß, Andreas
Posted : 20/04/2015 12:11 am
The difference is
a) the USB controller
b) the WinPC SW (which is bound to the serial number of the controller)
I had it as well but I stepped up to Mach3 and another USB controller which costed slighly more than the €199 but has much better results.
Frank
Steppcraft 600/2 + HF500 + SwitchBox + Laser + Schleppmesser
Absaugung und Vakuumtisch
an Mach3 oder UCCNC mit Taster für Z-Null und Werkzeuglänge
Posted : 20/04/2015 12:14 am
Topic starter
Thank you very much for your answers, if I was up all night looking information and realized that STEPCRAFT page, the difference between one version and the other is only explained in German, not English. I appreciate your answers.
Thanks
Posted : 20/04/2015 8:46 pm
