Benachrichtigungen
Alles löschen
Latest pcb's with indutrial VFD spindle
Engraving
1
Beiträge
1
Benutzer
0
Reactions
241
Ansichten
Themenstarter
For general interest.
Some pcb engraving/etching done recently using Eagle 8.1.0 and pcb to gcode ulp. Track widths and isolation set to 0.012" and engraved with single pas. Minimum hole size is 0.7mm. Tracks engraved using a 30degree carbide engraving bit set to cut to 0.008" deep. Spindle set to 18000rpm and 600mm/min for engraving and milling board cutout.
I think the engraving speed could be increased to nearer 1000mm/min without sacrificing quality - something to try on the next boards.
Peter
SC 420/2, Industrial VFD spindle from StoneyCNC
UC100 + UCCNC
Cut2D, Autosketch10, Draftsight, Eagle 9.5.1
There is no problem, however simple, that cannot be made more complicated by thinking about it.
Veröffentlicht : 14/05/2017 5:04 pm
Forum Information
- 44 Foren
- 7,406 Themen
- 63.4 K Beiträge
- 4 Online
- 26.5 K Mitglieder
Unser neuestes Mitglied: ethan34_lopez
Letzter Beitrag: NEW product: The Oscillating Tangential Knife OTK-3
Forum Icons:
Das Forum enthält keine ungelesenen Beiträge
Das Forum enthält ungelesene Beiträge
Themen-Icons:
Unbeantwortet
Beantwortet
Aktiv
Heiß
Oben angepinnt
Nicht genehmigt
Gelöst
Privat
Geschlossen