Benachrichtigungen
Alles löschen
Engraving
3
Beiträge
2
Benutzer
0
Reactions
6,556
Ansichten
Themenstarter
I have just purchased a woodburning pen. I wonder if it will work successfully with photoVcarve. Also it would be nice to have some idea of feeds and speeds.
Veröffentlicht : 14/08/2016 4:24 am
Themenstarter
AhHa, I have done it. My very first job. I configured a new profile in the Tool Database for wood burning pen.
I put it in Engraving tools.The picture below shows my settings.
You have to wait about 5 mins for the tool to heat up.
Make sure you don't tighten the collet too much or it will stop the spring loaded sleeve holding the iron inside from moving .
Also make sure you set the tool to cut on the line and not outside or inside.
Veröffentlicht : 14/08/2016 5:25 pm
The burnt image looks good, what type of wood is that and what feed rate did you use?
I see you used/ modified an engraving tool profile for your wood burning pen.
I found a youtube video for the stepcraft woodburningpen , it shows a tool profile setting too.
They use an endmill profile.
Veröffentlicht : 19/12/2016 5:52 pm
