file Frage How deep engraving eloxiert aluminium

Mehr
08 Apr 2016 01:39 #32925 von julius
How deep engraving eloxiert aluminium wurde erstellt von julius
I would engrave some serial numbers on an anodized alu plate (1mm thickness) but, at the same time, I don't want to damage too much the anodized layer that is protecting the material from corrosion/oxidation.
How much deep I can go with the engraving bit? 0.15-0.20 mm will be safe? :dry:
Or I should be no worry about it since the corrosion will attack only the engraved zones leaving the rest undamaged? Anybody has experience about that?

SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
08 Apr 2016 08:17 #32928 von Joules
If corrosion is a big worry, engraving will allow it to spread (slowly) under the anodising. I would make a mask for your engraved area, then apply clear lacquer to seal the area after engraving. Even nail varnish would seal the surface.

High Z S1000 router (out of action)
CamBam
Linuxcnc to be replaced by UCCNC + UC-100
OSX Rhino 3D

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
08 Apr 2016 12:22 #32938 von julius
Thanks for the idea Joules.
Any suggestion about what (cheap) sprayed product I could use? As I know it is not easy for a paint to adhere on an aluminium surface.
(Lacquer is not a finishing layer for the wood? It will be durable on alu?)

Dieses Bild ist für Gäste verborgen.
Bitte anmelden oder registrieren um das Bild zu sehen.


SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
08 Apr 2016 17:33 #32945 von Joules
The stuff they overcoat car body paint is also referred to as lacquer. Very hard wearing and will stick to anodised surfaces if the surface is degreased.

High Z S1000 router (out of action)
CamBam
Linuxcnc to be replaced by UCCNC + UC-100
OSX Rhino 3D

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
22 Apr 2016 22:38 #33443 von julius

Joules schrieb: The stuff they overcoat car body paint is also referred to as lacquer. Very hard wearing and will stick to anodised surfaces if the surface is degreased.

Where I can find that stuff? :unsure:

SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Powered by Kunena Forum

© 2022 STEPCRAFT GmbH & Co. KG

Wir benutzen Cookies

Wir nutzen Cookies auf unserer Website. Einige von ihnen sind essenziell für den Betrieb der Seite, während andere uns helfen, diese Website und die Nutzererfahrung zu verbessern (Tracking Cookies). Sie können selbst entscheiden, ob Sie die Cookies zulassen möchten. Bitte beachten Sie, dass bei einer Ablehnung womöglich nicht mehr alle Funktionalitäten der Seite zur Verfügung stehen.