file Frage Spindle twist on Tool Holder when tightening.

Mehr
23 Nov 2022 10:30 #62729 von [email protected]
Hi

A physical behavior with the Tool at tightening on the Tool Holder.

The table is the Z-axis 0°. (Electronic bevel) and the Tool Holder's Z-axis is at 0° too on x and y axis. Perfect settings.

When I install the Tool, it's Z/x and Z/y becames 0°,okay.

Then, I tighten the Tool and I get a move of the tool on the Z/Y axis in the Tool Holder at the last moment of tightening. Result... 0.5° twisted tool.

This is really a problem to mill flat pocket or for surface finishing.

May I need to replace the Tool Holder ? Mine is twisted ?

Thanks for any help.
Manu

Here a link to a movie to see it

1drv.ms/v/s!AiMQKzhNsuzMjLxsG0f4KG1TwbHJHw

manufv

manufv

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Powered by Kunena Forum

© 2022 STEPCRAFT GmbH & Co. KG

Wir benutzen Cookies

Wir nutzen Cookies auf unserer Website. Einige von ihnen sind essenziell für den Betrieb der Seite, während andere uns helfen, diese Website und die Nutzererfahrung zu verbessern (Tracking Cookies). Sie können selbst entscheiden, ob Sie die Cookies zulassen möchten. Bitte beachten Sie, dass bei einer Ablehnung womöglich nicht mehr alle Funktionalitäten der Seite zur Verfügung stehen.