Benachrichtigungen
Alles löschen
Assembly and Maintenance
2
Beiträge
2
Benutzer
0
Reactions
4,771
Ansichten
Themenstarter
I was told that there is a good way to align the Z axis, but haven't found the info. The bottom of a flat end mill is not parallel to the bed, so when cutting along the X or y axis, one edge of the cut is deeper than the other. To me it looks like siding on a house. Does anyone know a procedure to square it?. Hopefully a better way
than jamming tiny wood shims between the spindle and the mounting plate?
Veröffentlicht : 13/06/2019 1:10 am
Dear Jazzdad,
I wrote a guide to level the Z axis on this thread:
Doug
Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), https://dsgb.net
Veröffentlicht : 26/06/2019 5:17 pm
