Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Assembly and Maintenance
2
Beiträge
1
Benutzer
0
Likes
4,483
Ansichten
Themenstarter
Day 2 : Everything was working good the day before doing some initial tests by the help of a pen. On day 2 - when homing all motors, x-axis fail to move. It will stuck at about 10mm from the limit switch. Remove the motor and screw, and again when doing home it will jam at the same point. Moving the x-axis by the jog move it will work.
Any suggestions?
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
Veröffentlicht : 01/06/2016 11:09 pm
Themenstarter
Quick Update: After the suggestion and helpful hints from Rory , i manage to adjust this problem. It was from the M6 Bolts that holds the aluminium bar of the x axis. Move the the x axis end to end and than tight the M6 bolts. Once again a million thanks to Rory from StoneyCNC 🙂
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
Veröffentlicht : 02/06/2016 10:48 pm
