Benachrichtigungen
Alles löschen
Assembly and Maintenance
7
Beiträge
3
Benutzer
0
Reactions
4,098
Ansichten
Themenstarter
Hello everyone. I followed each step from the manual and also from various videos . I complete my system but before power it on , i just want to make sure that everything is well. i notice that the Y axis it is getting stuck and not able to reach the limit sensor. I am sure that this is not normal. How can i solve this problem ?? Any suggestions please.
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
Veröffentlicht : 29/05/2016 7:45 pm
Hi,
had here the same problem but I fixed it with a piece of self-adhestive felt. It's not very professional but works proper since some month.
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11
Veröffentlicht : 29/05/2016 8:18 pm
Themenstarter
So it is normal that it can't reach the switch??
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
Veröffentlicht : 29/05/2016 8:26 pm
Not normal, but as I remember I'm not the only one (and you) who have that problem. In the German forum part I've read it some time ago that another user had the same problem.
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11
Veröffentlicht : 29/05/2016 8:57 pm
You are not following the procedure.
Unscrew the Y axis screws, let the machine move till it touchs the switch, tighten the screws. That's all.
Repeat that for each extreme position of each axis.
Something like this but without totally unscrewing the screws: https://www.youtube.com/watch?v=GKEKqlukmYs
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Veröffentlicht : 30/05/2016 12:37 pm
Themenstarter
Thanks for the help @jvalencia. Now it is working fine 🙂 I install the Win-PC and move all axis with no problem.
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
Veröffentlicht : 30/05/2016 8:56 pm
Thanks for the help @jvalencia. Now it is working fine 🙂 I install the Win-PC and move all axis with no problem.
great!
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Veröffentlicht : 31/05/2016 9:41 pm
