Tool Length Sensor - TS-32
Hi All,
I was wondering if someone could help me please. I am just setting the Tool Sensor TS-32 and have configured the UNCNC software as per the instructions, https://www.stepcraft-systems.com/images/SC-Service/Anleitungen-EN/EN-Operating-Instructions-TLS_v1.pdf
In summary;
1) I have connected the sensor to the rear of the machine directly into the jack socket of the interface board
2) I have configured the Tool Length sensor, Probe Pin = 10 and Port = 1
3) I have download and replaced the M31.txt file
However once I have run the instruction as per "Use of the Tool Length Sensor in UCCNC" the software does not seem to store the calculate 0 value for the Z axis and the height is incorrect. I can manullay zero Z Axis.
Any ideas.
Many thanks,
Matt
- 44 Foren
- 7,406 Themen
- 63.4 K Beiträge
- 4 Online
- 26.5 K Mitglieder