Tool Changer with UCCNC
Hi
Is there anybody that already configured the toolchanger in UCCNC
I'm looking for the configured file M6.txt
My machine is flipping on this file
Regards
Narvick
Stepcraft2-600
4Th Axis
HF Spincle 500
Toolchanger
I faced up with the same problem. Does anybody know how to do it?
Hi, I am new to here but I have a little bit knowledge about UCCNC. It's a machine control software which used external hardware to generate signals and produce coordinated motion up to 6 machine axis. External hardware is a motion controller device.
Search the web for cnczone.com and uccnc and macro. You will find a M6 macro file in that forum. Maybe it works. M6
Found the link finally....
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11
- 44 Foren
- 7,406 Themen
- 63.4 K Beiträge
- 3 Online
- 26.5 K Mitglieder