question-circle Question PWM modulation WinPC-NC USB

  • CNCMiller
  • CNCMiller's Avatar Topic Author
  • Offline
  • Forum Nutzer
  • Forum Nutzer
More
02 Sep 2020 19:27 #59466 by CNCMiller
PWM modulation WinPC-NC USB was created by CNCMiller
Hello there,

Anyone with experience how to use the PWM mode on a laser with the WinPC-NC USB software?

I have a S 420 v.1 and use WinPC_NC v. 3.4 for the Laser I use a NEJE 20W (5,5W optic power) with TTL / PWM mode.
for generation of g-code I use the vectric Laser post processor "WinPC-NC ATC Arcs Laser No Z mm (*.nc)"

How can I use the PWM mode in combination with WinPC?
Witch pin do I use on the D15 connector (I assume pin 7 for PWM and pin for TTL mode) in combination with the GND?
What setting should I make in the WinPC programm to adjust the power of the laser (in M or G code )?
or should I make changes in the post-processor G-code?

Hope for some guidance in this.

SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum

© 2022 STEPCRAFT GmbH & Co. KG

We use cookies

We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.