Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Introduce Youself
2
Beiträge
2
Benutzer
0
Likes
3,350
Ansichten
Themenstarter
Hi all. Recently purchase the 840 with the MM-1000 and an Opt laser. I’m having issues with both and thought I would see if anyone could help.
MM-1000 - I have a lot of difficulty changing bit due to the collet holding them so tight. Anyone else seen this? Any advice?
Opt Laser 6w - I’m using VCarve with the addiotional Vetric PostP ( Stepcraft PWC inches). When I create a file with the new PostP the gcode is out of scale on my machine. Steppers run very slow and the actual design or picture is “printed” very small. Thoughts?
Veröffentlicht : 15/12/2018 6:49 am
Maybe a problem in your software chain? DXF-files do not contain the measuring unit. Which means you can happily work in one software with an inch setup and in another software with a mm setup without notification from any software.
Result being that the piece printed/milled/lasered will be too big or too small.
So, make sure that each software in your toolchain has the same setting for it's own work and maybe for import/export.
One other reason for scaling problems is, that SC1 has different mm/revolution settings than an SC2 has, but this would not result in a very small print. Just mentioned it for completeness.
SC 420 mit DIY parallel + Proxxon mit Mod + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +WinPC starter/USB->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch
Gruß, Andreas
Veröffentlicht : 17/12/2018 1:34 pm
