Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Engraving
6
Beiträge
3
Benutzer
0
Likes
6,169
Ansichten
Themenstarter
I would engrave some serial numbers on an anodized alu plate (1mm thickness) but, at the same time, I don't want to damage too much the anodized layer that is protecting the material from corrosion/oxidation.
How much deep I can go with the engraving bit? 0.15-0.20 mm will be safe? :dry:
Or I should be no worry about it since the corrosion will attack only the engraved zones leaving the rest undamaged? Anybody has experience about that?
SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple
Veröffentlicht : 08/04/2016 3:39 am
If corrosion is a big worry, engraving will allow it to spread (slowly) under the anodising. I would make a mask for your engraved area, then apply clear lacquer to seal the area after engraving. Even nail varnish would seal the surface.
High Z S1000 router (out of action)
CamBam
Linuxcnc to be replaced by UCCNC + UC-100
OSX Rhino 3D
Veröffentlicht : 08/04/2016 10:17 am
Themenstarter
Thanks for the idea Joules.
Any suggestion about what (cheap) sprayed product I could use? As I know it is not easy for a paint to adhere on an aluminium surface.
(Lacquer is not a finishing layer for the wood? It will be durable on alu?)
SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple
Veröffentlicht : 08/04/2016 2:22 pm
The stuff they overcoat car body paint is also referred to as lacquer. Very hard wearing and will stick to anodised surfaces if the surface is degreased.
High Z S1000 router (out of action)
CamBam
Linuxcnc to be replaced by UCCNC + UC-100
OSX Rhino 3D
Veröffentlicht : 08/04/2016 7:33 pm
Themenstarter
The stuff they overcoat car body paint is also referred to as lacquer. Very hard wearing and will stick to anodised surfaces if the surface is degreased.
Where I can find that stuff? :unsure:
SC300 + Spindle HF500 + Portalerhöhung + LinuxCNC + gsimple
Veröffentlicht : 23/04/2016 12:38 am
Aluminum is a common material in modern manufacturing. Industrial marking systems are used to generate unique identifiers directly on aluminum pieces.
Veröffentlicht : 26/03/2018 4:48 pm
