- Posts: 1
- Thank you received: 0
Question
Part Number 36 hitting Part Number 14
- blrussell66
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
12 Jul 2021 19:21 #61254
by blrussell66
This message has an attachment image.
Part Number 36 hitting Part Number 14 was created by blrussell66
When I try to install part number 26 Part number 36 hits Part number 14. This is on step 1.11 in my manual. I see no way for this to fit. What am I doing wrong. see the attached picture. I did try to install the correct way from the manual. I just just took the end cap off to see how much off I am.
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.
- Volker Bunge
-
- Offline
- Forum Nutzer
-
Less
More
- Posts: 256
- Thank you received: 53
14 Jul 2021 08:50 #61256
by Volker Bunge
Stepcraft V2 420, WinPC-NC USB Vollversion + HR10, EstlCam 10+XBox-Controller, HF500, Schwebehalter, Schleppmesser, Heißschneidedraht
Replied by Volker Bunge on topic Part Number 36 hitting Part Number 14
Hello, blrusssel66,
take a look at this post www.stepcraft-systems.com/forum/aufbau/6601-problem-bei-m-700-montage .
Here it was a wrong assembly of the plate. Maybe it's the same with you.
So check the previous steps and compare the pictures carefully.
Greeting
Volker
take a look at this post www.stepcraft-systems.com/forum/aufbau/6601-problem-bei-m-700-montage .
Here it was a wrong assembly of the plate. Maybe it's the same with you.
So check the previous steps and compare the pictures carefully.
Greeting
Volker
Stepcraft V2 420, WinPC-NC USB Vollversion + HR10, EstlCam 10+XBox-Controller, HF500, Schwebehalter, Schleppmesser, Heißschneidedraht
Please Log in or Create an account to join the conversation.