Installation steps 2.1, 2.1, 5.2 and 6.5

Assembly and Maintenance

Letzter Beitrag von Jonathan Vor 8 Jahren

3 Beiträge

3 Benutzer

0 Likes

4,125 Ansichten

RSS

Mohammed Ashraf

(@ivsystems)

Beiträge: 1

New Member

Themenstarter

Dears
I'm installing my Stepcraftv2 840 CNC and I have a huge difficulty aligning parts as shown in the attached images from the installation manual (Installation steps 2.1,5.2 and 6.5 asks you to leave 1mm from 2 dimensions and I don't know how to do that)

also what is the impact of a misalignment (the 1mm is not achieved) on the overall accuracy of the machine ?
is there any other way to overcome this issue ?

Best Regards

Veröffentlicht : 29/05/2016 12:20 am

Hartmut

(@docbrown)

Beiträge: 506

Honorable Member

I had the same problem but I think the most important thing is, that everything has the same distance. I cannot see any problem if all distances are 0.5mm or so.

Viele Grüße

Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11

Veröffentlicht : 29/05/2016 3:55 pm

Jonathan

(@calleja)

Beiträge: 41

Trusted Member

Yes it is difficult to leave 1mm on each end as shown in the manual. At the end i had to adjust them again and the final stage .

Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop

Veröffentlicht : 29/05/2016 9:01 pm