Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Assembly and Maintenance
2
Beiträge
2
Benutzer
0
Likes
4,265
Ansichten
Themenstarter
I have just finished building my Stepcraft 600.Enjoyable experience 🙂
I have purchased the UC100 from StoneyCNC.
I have Mach3 installed and have used the CNCdrive autoinstall, which I downloaded and ran.
When I open Mach 3 I have two choices of UC100 - V2 127 and V2 146 but there is no Stepcraft profile as seen in the instructions from Stoney.
Do I have to download this file? If so, where? I cant seem to find it.
Thanks
David
Veröffentlicht : 22/03/2015 5:05 pm
PM Rory From SToneyCNC.
He sent me the 420 version which I could change to 600 (the x/y settings in homing/limits) . Depending what spendle you use you may need to change the setup as well (like I did with HF500).
On top you can change some other parameters, like speed and slope of motors, depending if you have 30V power supply or the normal 19Vand also backlash.
Frank
Steppcraft 600/2 + HF500 + SwitchBox + Laser + Schleppmesser
Absaugung und Vakuumtisch
an Mach3 oder UCCNC mit Taster für Z-Null und Werkzeuglänge
Veröffentlicht : 22/03/2015 11:30 pm
