file Frage Configuring UCCNC with STEPCRAFT machine

Mehr
07 Okt 2014 15:53 #8901 von Rory
Hello! We would like to hear what you think of the UCCNC software.

Do you have a UC100?
Have you purchased a UCCNC license for your UC100?

Wobbie schrieb: Hi there i have a s420, now trying uccnc , but dont seem to be getting the settings correct, is there a file like with mach3 xml
this may make it easyer
cheers all


There is an equivalent file yes - you need the file and the Macro folder.

let us know what stage you have got to.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
07 Okt 2014 21:59 #8912 von Wobbie
I have uninstalled all of it and going to start again, hope you can help me out,
yes i have a UC100 and licence from cnc drive
this is a great forum

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
08 Okt 2014 01:00 #8914 von Rory
Okay - so you have an active installation of UCCNC - its important the UCCNC is not running in demo mode as this will not allow signals to get to the STEPCRAFT using the UC100.

Please send us an email (stoneycnc) - the configuration file installer cannot be attached to the forum.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
16 Nov 2019 21:28 #57644 von Fillingham
Fillingham antwortete auf Configuring UCCNC with STEPCRAFT machine
I can't seem to change the y-axis velocity in UCCNC. I wanted to push it higher to test after y-axis alignment, but when I type in a new value and press apply it changes back to 2600. I am sure this worked ok when I first went through this process.

Stepcraft S420
UCCNC
VCarve Desktop v10

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
16 Nov 2019 23:24 #57645 von andileibi
andileibi antwortete auf Configuring UCCNC with STEPCRAFT machine

Fillingham schrieb: .....but when I type in a new value and press apply it changes back to 2600.....


After changing the value you have to press enter, then you can apply it.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
17 Nov 2019 00:01 #57646 von Fillingham
Fillingham antwortete auf Configuring UCCNC with STEPCRAFT machine
Thanks andeleibi. I will try that.

Stepcraft S420
UCCNC
VCarve Desktop v10

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Powered by Kunena Forum

© 2022 STEPCRAFT GmbH & Co. KG

Wir benutzen Cookies

Wir nutzen Cookies auf unserer Website. Einige von ihnen sind essenziell für den Betrieb der Seite, während andere uns helfen, diese Website und die Nutzererfahrung zu verbessern (Tracking Cookies). Sie können selbst entscheiden, ob Sie die Cookies zulassen möchten. Bitte beachten Sie, dass bei einer Ablehnung womöglich nicht mehr alle Funktionalitäten der Seite zur Verfügung stehen.