Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
WINPC-NC : ERROR Homing switch active
Operation
3
Beiträge
3
Benutzer
0
Likes
2,815
Ansichten
Themenstarter
Got Stepcraft M100 construction kit.
After starting WinPC-Nc Starter software and trying to make "inizialing the machine" action got ERROR "Homing switch active"
While manual moving on XYZ directions is ok.
What's wrong?
Veröffentlicht : 22/02/2021 8:50 pm
check your connections of the Stepper motors to the mainboard and/or the endswitches.
This error shows when a connection is bad or broken.
In winpc go to the Special functions menu and select signal test, now you can possibly see where it goes wrong.
good luck
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Veröffentlicht : 24/02/2021 9:42 pm
I had the same problem and it turned out that I had connected the two wires on my Y-axis home button not correct (should be the two outer connectors only
Veröffentlicht : 14/08/2021 2:45 pm
Forum Information
- 44 Foren
- 7,341 Themen
- 63.2 K Beiträge
- 31 Online
- 26.3 K Mitglieder
Unser neuestes Mitglied: HannoR
Forum Icons:
Das Forum enthält keine ungelesenen Beiträge
Das Forum enthält ungelesene Beiträge
Themen-Icons:
Unbeantwortet
Beantwortet
Aktiv
Heiß
Oben angepinnt
Nicht genehmigt
Gelöst
Privat
Geschlossen